WaterPro Well Stop Water Detection Sensor 230V

WaterPro™ Well Stop — Water Detection Sensor for Well Pumps (230V)

The WaterPro™ Well Stop is a water detection sensor that connects to a pressure switch via a built-in power relay. When water is detected, it automatically cuts power to your well pump to prevent flooding. Available in 120V and 230VAC bare lead (no plug) 15-amp models.

How It Works

Bare lead models connect in-line with a pressure switch. Once field-installed and powered, the green LED illuminates to indicate normal operation. When water contacts the two probes, the red LED illuminates and the internal relay disconnects power to the well pump. The system must be manually reset by pressing the reset button — power loss or evaporation will not restore operation on its own. The sensor uses an isolated patented circuit that detects water at 1/16" with no shock hazard at the probes.

Specifications

• Primary Voltage: 220/230V
• Amperage: 15A
• Cable Length: 10 ft (3.05 m)
• Cable Type: SJOOW, 14 AWG, 3-Conductor
• Detection Level: 1/16" of water

Overview: WaterPro Well Stop installation and operation